Architectural Y Hanger

• Unscrew lockable plunger anti clockwise allowing it to actuate, do not unscrew fully
• Feed vertical wire support through top of the plunger until it appears at the side exit
• Pull wire through side exit allowing a tail of 75mm minimum
• Now screw lockable plunger clockwise to lock off the device

Levelling the fixture:

• Use a 2.5mm hex key bit to loosen the grub screw located in the base of the device, do not unscrew fully
• Move inverted Y shape wire until fixture is level
• Tighten grub screw clockwise to lock Y shape wire into place, do not over tighten